Install MASM 6.15, click link (http://zwang.vwc.edu/~jwang/
ThreeTen/_setup.zip) to download it and install to your computer by
following the instructions. Then the program should be stored in C:\Masm615\
IF there are error messages, just ignore that.
You're done!
Step 1: Build 32-bit MASM
Select Preferences from the Configure menu.
Select Tools in the left hand pane, and click the Add
button.
Select "DOS command..." from the drop-down list. When the popup dialog
appears, enter the following and click OK:
C:\Masm615\make32.bat $BaseName
Click the Apply button.
Next, you will rename the command to Build 32-bit MASM. To do this,
click once on the name, wait a second, and click again. When it turns blue,
retype the command's name and press Enter.
Click Apply to save the setting.
Select the Tools menu, and click on Build 32-bit MASM command. In the right-hand pane,
Clear the
Capture output options.
Following is a sample screen snapshot.
Click OK to save your changes and quit.
Step 2: Run ASM Prog
Similar steps as the above, except for the parameters
Select Preferences from the Configure menu
Select Tools in the left hand pane, and click the Add button
on the right side
Select DOS command... from the drop-down list. When the popup
dialog appears, enter the following and click OK:
$BaseName
Click the Apply button.
Next, rename the command to Run ASM Prog. To do this, click once on
the name, wait a second, and click again. When it turns blue, type the
command's name and press Enter. Click Apply.
Click on the "+" next to Tools in the left-hand pane. When the list
expands, select Run ASM Prog. In the right hand pane of the dialog,
remove the check mark next to Capture output.
Click OK to close the dialog and save your changes.
You're done!
Step 3: Run an sample MASM
Start the TextPad program, and go to the following directory.
C:\Masm615\Examples\ch03
Select AddSub.asm file.
Assembly the Prog: Click on Tools, and
then External Tools, and then select Build 32-bit MASM. The
popup console appears, as follows. Press any key to kill the console.
Run the Prog: Click on Tools, and
then External Tools, and then select Run ASM Prog. The popup
console appears, as follows. Press any key to kill the console.